Question: Do You Need Two Curtain Rods To Hang A Valance?

How do you hang two sets of curtains?

It’s simple, just hang your blackout curtains on a bungee cord behind your decorative curtains – no one will see the cord and assembly is a breeze!.

How do you hang sheers over a curtain rod?

Wrapping Around Curtain RodLay the sheer out straight and fold it in half. … Place the center of the sheer on the center of the curtain rod and attach with a large binder clip or a piece of masking tape. … Wrap the sheer over the curtain rod several times on each side of the binder clip.More items…

Can you hang curtains without a curtain rod?

A moderate to heavy gauge wire could also be used in lieu of a curtain rod. It is another quick, easy, and inexpensive way to hang your window coverings. You will need brackets or something on each side of the wall to wrap the excess wire around.

How do you hang a valance on a curtain panel?

Making and Adding a Valance to a Pair of Curtains:Cut the fabric to the required length. … Turn in a double 1″ (2.5 cms) hem down both side edges and along the bottom and pin. … Pin the fringing along the bottom edge, close to the fold, turning in 1″ (2.5 cms) at each end to neaten.More items…

How much wider than the window should a valance be?

Most valances should only be 1-1/2 to 5 inches wider than the window if the valance hangs by itself or over a Roman shade. It should be 10 to 30 inches wider than the window if it’s hung over a pair of custom drapes. If the valance is gathered, its total, flat width should be 2 to 3.5 times the width of the window.

Can you use nails to hang curtain rods?

If you have traditional paned windows with frames tension rods that stretch from one side of the frame to the other are a subtle and sophisticated way to hang curtains. … Use the hammer to place the nails securely on the sides of the window frame.

How can I hang curtains without putting holes in the wall?

Renter-Friendly Window Treatments That Don’t Damage WallsUse Temporary Command Hooks.Hang Curtains With Tension Rods.Order Custom Compression Shades.Make a Faux Roman Shade.Buy Twist & Fit Curtain Rods.Suspend Curtain Rods from the Ceiling.

Can you hang two curtains one rod?

Another smart way to achieve a layered look using a single rod is to use double-sided hooks. Though these are often used in bathrooms for shower curtains, they can be adopted in other rooms as well. Double-sided hooks have two hooks on opposite sides, which can be used to hold two curtain panels at the same time.

Where do you hang a curtain rod for a valance?

Tip #1: Hang the Window Treatment High The pole or valance should be positioned a minimum of 4 inches and a maximum of 12 inches above the top of the window in most cases. Even a budget valance or unlined curtain panel can look well done and professional when hung at the proper height above the window.

Do I need wall anchors for curtain rods?

You’ll need to use plastic wall anchors to provide proper support if you’re installing in drywall. Fasten the brackets to the walls using your drill or screwdriver. … Hang the curtains and double-check to make sure your brackets are still secure. Open and close to check that they’re functioning properly before finishing.

Do you need two curtains per window?

Example: If your window measures 36″ wide (window width x 2 = 72″), you need curtains that will give a minimum width of 72″ or 2 panels for that window. In this case 2 panels will give about 100″ to 120″ of width which will look nice and full. Always round up to the next full number.

How do you hang two different colored curtains?

When making your choice, hold panels next to each other until you get the look you want.Layer Them. Install a double curtain rod, and hang the lightest-colored panel against the window and the darker one in front of it. … Create a Pattern. … Working With Two Panels. … Different Colors on Windows in the Same Room.

How far should a curtain rod extend past window?

When installing curtain rods, hang the rod so that it extends at least 3 or 4 inches beyond the window on each side, which allows your curtains to overlap both the window and the wall to prevent light from leaking in around the window’s edges.

Should curtain touch the floor?

So should curtains touch the floor? The short answer is yes… usually. But when making any decision about your window treatments, whether they’re drapes, blinds, or shades, it’s important to consider every aspect of style and function so you can choose the best option for your windows and your home.

Why have a double curtain rod?

When used together, this layer of drapes gives the window and room a very distinct look. The best way to ensure that both drapes look and hang correctly is to use a double curtain rod. A double curtain rod allows the drapes to serve their purpose while keeping things nice and clean looking.

Should sheers and curtains be the same length?

Like with curtains, you want your sheers to have a bit of a wave to them. … With the height, if used in conjunction with a floor length curtain, you can either have the sheer the same length (or just an inch shorter) or only have the sheers hang down to the sill.

How do you hang a valance without a rod?

You can hang is on a board and nail the board to the wall; use velcro. Use the type that is sticky on both sides. The big box stores carry it.

How do you hang a curtain on a double rod?

How to Install Double Curtain Rods the Traditional WayStep 1: Measure Your Curtains. Clean and inspect the window and frame for leaks and damage. … Step 2: Gather Your Supplies & Tools. … Step 3: Prepare the Window Space. … Step 4: Install Your Double Curtain Rod Brackets. … Step 5: Hang Your Curtains.

How far down should a valance hang?

Another rule of thumb used by decorators is that the window valance depth should be 1/4 of the overall window height, plus 1 inch. A 60-inch tall window, then, would call for a 16-inch deep valance, while a 48-inch window calls for a valance about 13 inches deep.